Vac Vintage Preamplifier User Manual

Browse online or download User Manual for Audio Vac Vintage Preamplifier. VAC Vintage Preamplifier User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 3
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Valve Amplification Company
1731 Northgate Boulevard, Sarasota, FL 34234 USA
Telephone 941-359-2066 / Fax 941359-2057
www.vac-amps.com
VAC VINTAGE PREAMPLIFIER Mk III
Operating Instructions
DO NOT OPEN THIS UNIT - THERE ARE NO USER SERVICEABLE PARTS INSIDE.
DO NOT TOUCH TUBES UNTIL UNIT HAS BEEN SWITCHED OFF FOR 5
MINUTES. TUBES BECOME HOT IN USE. DO NOT EXPOSE THIS UNIT TO
MOISTURE. DO NOT PLUG INTO AN AC SOURCE UNTIL ALL CONNECTIONS
ARE COMPLETED.
Introduction
The Vintage Preamplifier features a zero-global-feedback, Class A, triode line amplifier &
controller, and a Class A triode phono amplifier employing both passive and active RIAA
equalization techniques. It is to be operated from the voltage labeled on the back panel, 50-
60 Hz. The fuse is a slow blow type of the size labeled on the back of the unit.
Connection
1.Complete all connections before connecting the AC cord to the wall outlet.
2.At turn on, the volume control should be full counter-clockwise and the mode switch
should be set to MUTE. Also, always MUTE the preamp before switching power off,
to prevent damage to amplifiers or speakers.
3.Allow 30 seconds for warm up before leaving MUTE.
4.The Vintage Preamplifier inverts phase from all inputs to the main outputs. To correct
for this reverse the speaker connections in both channels. Output to the tape jacks
does not invert.
5.In normal operation no signal is present at the tape output jacks. This is done to
ensure that no degradation of sound occurs due to input non-linearities or loading
Page view 0
1 2 3

Summary of Contents

Page 1 - Valve Amplification Company

Valve Amplification Company1731 Northgate Boulevard, Sarasota, FL 34234 USATelephone 941-359-2066 / Fax 941–359-2057www.vac-amps.com VAC

Page 2

effects of the tape recorder. To record, select the record enable position ("TAPE ON")of the TAPE MONITOR switch. If you wish to monitor the

Page 3

mechanical or acoustic stimulation encountered when the unit is properly installed andplaying music. Replace the offending tube if excessive mechanica

Comments to this Manuals

No comments